ZyXEL Communications Network Router NOT AVAILABLE Manual de usuario descargar pdf (Pagina 50)

Chapter 6 Interfaces

NXC CLI Reference Guide

The following sections introduce commands that are supported by several types of interfaces.

6.2.1 Basic Interface Properties and IP Address Commands

This table lists basic properties and IP address commands.

profile_name The name of the DHCP pool. You may use 1-31 alphanumeric characters,

underscores(

_), or dashes (-), but the first character cannot be a number. This

value is case-sensitive.

domain_name Fully-qualified domain name. You may up to 254 alphanumeric characters,

dashes (-), or periods (.), but the first character cannot be a period.

Table 12 Input Values for General Interface Commands (continued)

LABEL DESCRIPTION

Table 13 interface General Commands: Basic Properties and IP Address Assignment

COMMAND DESCRIPTION

show interface {ethernet | vlan} status Displays the connection status of the specified type

of interfaces.

show interface {interface_name | ethernet |

vlan | all}

Displays information about the specified interface,

specified type of interfaces, or all interfaces.

show interface send statistics interval Displays the interval for how often the NXC

refreshes the sent packet statistics for the

interfaces.

show interface summary all Displays basic information about the interfaces.

show interface summary all status Displays the connection status of the interfaces.

[no] interface interface_name Creates the specified interface if necessary and

enters sub-command mode. The

no command

deletes the specified interface.

[no] description description Specifies the description for the specified interface.

The no command clears the description.

description: You can use alphanumeric and

()+/:=?!*#@$_%- characters, and it can be up

to 60 characters long.

[no] downstream <0..1048576> This is reserved for future use.

Specifies the downstream bandwidth for the

specified interface. The

no command sets the

downstream bandwidth to 1048576.

exit Leaves the sub-command mode.

[no] ip address dhcp Makes the specified interface a DHCP client; the

DHCP server gives the specified interface its IP

address, subnet mask, and gateway. The

command makes the IP address static IP address

for the specified interface. (See the next command

to set this IP address.)

[no] ip address ip subnet_mask Assigns the specified IP address and subnet mask

to the specified interface. The

no command clears

the IP address and the subnet mask.

[no] ip gateway ip Adds the specified gateway using the specified

interface. The

no command removes the gateway.

ip gateway ip metric <0..15> Sets the priority (relative to every gateway on every

interface) for the specified gateway. The lower the

number, the higher the priority.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 299 300

Comentarios a estos manuales

Sin comentarios

ZyXEL Communications Network Router NOT AVAILABLE Manual de usuario Pagina 50

Comentarios a estos manuales

Relacionado con productos y manuales para Software ZyXEL Communications Network Router NOT AVAILABLE