
Chapter 13 Wireless Load Balancing
NXC CLI Reference Guide
101
13.2.1 Wireless Load Balancing Examples
The following example shows you how to configure AP load balancing in "by station" mode.
The maximum number of stations is set to 1.
The following example shows you how to configure AP load balancing in "by traffic" mode.
The traffic level is set to low, and "disassociate station" is enabled.
Router(config)# load-balancing mode station
Router(config)# load-balancing max sta 1
Router(config)# show load-balancing config
load balancing config:
Activate: yes
Kickout: no
Mode: station
Max-sta: 1
Traffic-level: high
Alpha: 5
Beta: 10
Sigma: 60
Timeout: 20
LIInterval: 10
KickoutInterval: 20
Router(config)# load-balancing mode traffic
Router(config)# load-balancing traffic level low
Router(config)# load-balancing kickout
Router(config)# show load-balancing config
load balancing config:
Activate: yes
Kickout: yes
Mode: traffic
Max-sta: 1
Traffic-level: low
Alpha: 5
Beta: 10
Sigma: 60
Timeout: 20
LIInterval: 10
KickoutInterval: 20
Comentarios a estos manuales