ZyXEL Communications Network Router NOT AVAILABLE Manual de usuario descargar pdf (Pagina 228)

Chapter 35 File Manager

NXC CLI Reference Guide

228

35.5 File Manager Command Example

This example saves a back up of the current configuration before applying a shell script file.

35.6 FTP File Transfer

You can use FTP to transfer files to and from the NXC for advanced maintenance and support.

35.6.1 Command Line FTP File Upload

1 Connect to the NXC.

2 Enter “bin” to set the transfer mode to binary.

3 You can upload the firmware after you log in through FTP. To upload other files, use

“cd” to change to the corresponding directory.

4 Use “put” to transfer files from the computer to the NXC.

For example:

In the conf directory, use "put config.conf today.conf” to upload the configuration file

(config.conf) to the NXC and rename it “today.conf”.

"put 1.00(XL.0).bin” transfers the firmware (1.00(XL.0).bin) to the NXC.

show running-config Displays the settings of the configuration file that the

system is using.

setenv-startup stop-on-error off Has the NXC ignore any errors in the startup-

config.conf file and apply all of the valid commands.

show setenv-startup Displays whether or not the NXC is set to ignore any

errors in the startup-config.conf file and apply all of the

valid commands.

write Saves your configuration changes to the flash (“non-

volatile” or “long term”) memory. The NXC immediately

uses configuration changes made via commands, but if

you do not use the

write command, the changes will

be lost when the NXC restarts.

Table 136 File Manager Commands Summary (continued)

COMMAND DESCRIPTION

Router(config)# copy running-config /conf/backup.conf

Router(config)# run /script/vpn_setup.zysh

1. When you upload a custom signature, the NXC appends it to the existing custom signatures stored in the

"custom.rules” file.

1 2 ... 223 224 225 226 227 228 229 230 231 232 233 ... 299 300

Sin comentarios

ZyXEL Communications Network Router NOT AVAILABLE Manual de usuario Pagina 228