ZyXEL ACCESSING INTERNET & INTRANET omni series Manual de usuario descargar pdf (Pagina 39)

ISDN Communication Basics 27

The omni supports either verbose result code (i.e. “OK”) or

numerical result code (i.e. “0"). You can use ATVn command to set

it one way or the other:

Command Description

ATV0 Select numerical result code.

ATV1 Select verbose result code.

Outgoing Calls

The omni has 3 modes in which to send communication over ISDN

network.

• ISDN data.

• Analog port, Phone 1 communication (non-data).

• Analog port, Phone 2 communication (omni.net).

These modes are auto-switching based on the commands you issue.

Let’s take a look at how the communication mode is automatically

switched. At your terminal program, proceed with the following

instructions:

Dialing out using ISDN mode

The command “ATDI” tells your TA that you want to make an ISDN

data call and to therefore use the ISDN mode to call out.

Type:

ATDI17142630398<enter> (Make an ISDN call)

Dialing out using ISDN mode’s optional Speech Bearer

Service

Your TA supports ISDN data utilizing Speech Bearer Service. To

enable this function, you need to set S-register S83 bit 7 to 1

(ATS83.7=1). This function is useful in the areas where ISDN

service providers charge lower usage rate for voice (speech) calls. To

enable this function, type:

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 167 168

Sin comentarios

ZyXEL ACCESSING INTERNET & INTRANET omni series Manual de usuario Pagina 39