ZyXEL ACCESSING INTERNET & INTRANET omni series Manual de usuario Pagina 21

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 168
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 20
Installing omni External Models 9
Front Panel Switch
When the TA is in command state, pressing the front panel button
causes it to dial the default phone number pre-stored in the NVRAM.
The default number pointer to the telephone directory is assigned by
the AT*Dn command.
When the TA is on-line, pressing the button will tear down the
connection and bring it into command state.
To restore the TA to its factory default settings and initiate the
loop-back test, turn the power ON while pressing and holding the
switch. Continue holding the switch for 3 to 5 seconds after turning
the power ON.
Back Panel
You will find the following switch and connectors on the back panel
of the omni external models:
Figure 2-1 omni.net Back Panel
ON/OFF - Power switch; turns the omni ON or OFF.
POWER - Input terminal for power adapter.
To DTE - Serial port DB-25 female connector for connection to the
serial port of a DTE (computer/terminal).
ISDN - ISDN RJ-45 terminal jack; connects to a S/T interface or a U
interface.
PHONE 1 (omni.net) - RJ-11 terminal jack for analog adapter 1; for
connecting to analog equipment. (phone, fax, answering machine,
etc.)
Vista de pagina 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 167 168

Comentarios a estos manuales

Sin comentarios