
Chapter 6 LAN
FSG1100HN User’s Guide
6.4 LAN General Screen
The LAN window General tab allows users to configure and display LAN settings. A
Local Area Network (LAN) is a shared communication system to which many
computers are attached. A LAN is a computer network limited to the immediate area,
usually the same building or floor of a building. The LAN windows can help users
configure a LAN DHCP server, manage IP addresses, and partition the physical
network into logical networks.
Click Networking > LAN > General to open the LAN screen.
Networking > LAN > General
The following table describes the LAN general labels in this screen.
Networking > LAN > General
Enter the (LAN) IP address of the FSG1100HN in dotted
decimal notation 192.168.1.254 (factory default).
The subnet mask specifies the network number portion of an IP
address. The FSG1100HN
will automatically calculate the
subnet mask based on the IP address assigned by the user.
Unless a user is implementing subnetting, use the subnet mask
computed by the FSG1100HN. Enter the subnet mask in dotted
decimal notation.
Enter a default gateway IP address. This is for use with a
DHCP server (see the next field).
Select Server, Client, or Disabled. If Server is selected,
assign a range of IP addresses below in the DHCP Client
Range fields and an IP address for the Default Gateway field
above.
Range
When Server is selected, assign a range of contiguous IP
addresses. Click Show Client to display the read-only Active
DHCP Client Table displayed on the next page.
Enable or Disable static DHCP. To set up static DHCP,
Comentarios a estos manuales