ZyXEL P-661H Series Manual de usuario descargar pdf (Pagina 85)

Chapter 4 WAN Setup

P-661H/HW Series User’s Guide

4.6.2 Configuring More Connections Advanced Setup

To edit your ZyXEL Device's advanced WAN settings, click the Advanced Setup button in

the More Connections Edit screen. The screen appears as shown.

Figure 42 More Connections Advanced Setup

The following table describes the labels in this screen.

Cancel Click Cancel to begin configuring this screen afresh.

Advanced Setup Click this button to display the More Connections Advanced screen and edit

more details of your WAN setup.

Table 27 More Connections Edit (continued)

LABEL DESCRIPTION

Table 28 More Connections Advanced Setup

LABEL DESCRIPTION

RIP & Multicast

Setup

RIP Direction Select the RIP direction from None, Both, In Only and Out Only.

RIP Version Select the RIP version from RIP-1, RIP-2B and RIP-2M.

Multicast IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to

establish membership in a multicast group. The ZyXEL Device supports both IGMP

version 1 (IGMP-v1) and IGMP-v2. Select None to disable it.

ATM QoS

ATM QoS Type Select CBR (Continuous Bit Rate) to specify fixed (always-on) bandwidth for voice

or data traffic. Select UBR (Unspecified Bit Rate) for applications that are non-time

sensitive, such as e-mail. Select VBR-nRT (Variable Bit Rate-non Real Time) or

VBR-RT (Variable Bit Rate-Real Time) for bursty traffic and bandwidth sharing with

other applications.

Peak Cell Rate Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find the Peak Cell

Rate (PCR). This is the maximum rate at which the sender can send cells. Type the

PCR here.

Sustain Cell Rate The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can be

transmitted. Type the SCR, which must be less than the PCR. Note that system

default is 0 cells/sec.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 357 358

Sin comentarios

ZyXEL P-661H Series Manual de usuario Pagina 85