ZyXEL P-2024 Manual de usuario descargar pdf (Pagina 5)

P-2024 Quick Start Guide

2 Making Hardware Connections

This section describes how to connect the P-2024 to your network and prepare it for

configuration.

Take the following steps to connect the P-2024 to your network:

1 Connect the Telco-50 (RJ-21) cable to the PHONE connector and tighten the retaining

screw.

See Section 2 on page 4 for information on configuring and using the Telco-50 cable to

connect the P-2024 to your telephones or a Main Distribution Frame (MDF).

2 Use an Ethernet cable to connect your computer to the LAN port.

3 Use another Ethernet cable to connect your switch or router to the WAN port.

4 Connect a suitable power source to the AC INPUT power socket using the included

power cable. Turn on the power.

5 Look at the LEDs on the P-2024.

The 1 ~ 24 analog phone port LEDs flash during startup. Once the P-2024 has started up

successfully:

• If an analog phone is connected to a port, the port’s LED blinks when the phone is

off-hook.

• If an analog phone port has a registered SIP account assigned to it, the port’s LED

stays steady on. The LED blinks when a call is incoming on the SIP account, even if

no phone is connected.

The PWR/STATUS LED turns steady on when the P-2024 has started up successfully.

1 2 3 4 5 6 7 8 9 10 ... 16 17

Sin comentarios

ZyXEL P-2024 Manual de usuario Pagina 5