ZyXEL RS-1612 Manual de usuario

RS-1612User’s GuideVersion 1.0JiH5<ACCESSING INTERNET & INTRANET

x

1IntroductionCongratulations on your purchase of the RS-1612 series racksystem, one of ZyXEL’s premier high performance products. TheRS-1612 chassis

2Other ResourcesFor more information about the RS-1612 series rack system checkthe following sources:• U-336R/RE User's Guide The U-336R/RE Use

3• One Menu Tree Guide• One Warranty Registration Card

4

5Primary ComponentsMost operations you will perform with your RS-1612 rack systemwill involve the primary components. This chapter gives you anoverv

6LCD PanelThe LCD panel shows the current operating status for the rack orvarious configuration menus.Menu KeyThe Menu Key is used to choose which dis

7panel. For racks with redundant power supplies, turning bothpower supplies on ensures the rack remains energized if one powersupply fails.FuseThe fus

8 Figure 2-2 RS-1612 Rear PanelDTE RS-232 PortsThe RS-1612 rack has sixteen DTE RS-232 ports. Each portcorresponds to a modem card slot on the front.

96 RX For use on four-wire leased linesystems receiving line (R model only).7 TX Transmits for four-wire leased lines,transmits and receives for two-w

iiZyXEL Limited WarrantyZyXEL warrants to the original end user (purchaser) that thisproduct is free from any defects in materials or workmanship for

1010Base2, 10Base5, 10Base-TThese connectors are used to connect the RS-1612 to a LAN.ZyView can manage the RS-1612 via the LAN. Only one of thethree

11InstallationThis chapter gives detailed instructions for installing one or moremodems into the rack.Setting up the RS-1612 RackSetting up the RS-1

122. Holding both screw knobs, pull the card straight out.Phone LinesSixteen terminal blocks correspond to the sixteen modem card slotsin the rack. E

132. Replace the control panel.3. Make sure all other hardware installations are complete.4. Switch the power source selector on the back panel to

143. Power on the rack and wait until you see the Press ENTER tocontinue… prompt.4. Press Enter and the following message is displayed: Enter Passwor

15 or nms mask add <IP address> [mask] and press Enter. Mask, as given in this command, is a 16-bit value. Each bitcorresponds to a modem slot.

16IP address configuration:Command Descriptionsys ip <addr> [netMask] Defines IP address and subnetmask.sys ip gateway <addr> Defines defa

17Command Description<new passwd>sys password save Saves password.Change Baud rate of RS-232:Command Descriptionsys baud x Changes and saves bau

18

19OperationThis chapter gives information on day to day use of the RS-1612rack system. Most of what you will do with the rack involvesconfiguring or

iiilegal rights, and you may also have other rights which vary fromstate to state.Copyright © 1997 by ZyXELThe contents of this book may not be reprod

20• Contrast Menu - The Contrast menu lets you adjust thecontrast of the LCD display.• Modem Reset Menu - This menu allows you to reset themodem wit

21modem you are about to configure occupies, some key modemsettings, major configuration categories, and the type of modem.Refer to the Menu Tree Guid

22 ZyXEL RS-1612 >> VER : 1.0 IP = 203.66.113.10 Figure 4-3 Main DisplayMessage DisplayThe message display shows brief messages sent by th

23<< LCD CONTRAST >> 0 1 2 3 4 5 6 7 ^ Figure 4-5 Contrast MenuModem Reset MenuThe Modem Reset Menu lets you reset the modem wit

24Setting the Display ContrastChanging the display contrast makes it easier to read the display.1. From the Main Display, press the Right Arrow Key t

25 1 stop bit3. Turn on the RS-1612 rack to reboot the system. Type in anycharacter to enter debug mode.4. Change the data rate to 115200 bps using

26Setting Modems with the Control PanelEach modem card in the RS-1612 series chassis can be configuredthrough the control panel. To access the modem c

27Changing Modem CardsWhen the rack is powered up, the control card reads each modemcard's settings in the rack and stores the modem settings, It

ivand if not installed and used in accordance with the instructions,may cause harmful interference to radio communications.If this equipment does caus

vinstalled using an acceptable method of connection. In some cases,the company’s inside wiring associated with a single line individualservice may be

viwith ITU-TSS recommendation. This product complies with thefollowing directives:1. The Council Directive 89/336/EEC of 3 May 1992 on theapproximati

vii• Technical support: [email protected] in North [email protected] outside North America.• Product information: Visit our site on th

viiiContentsZyXEL Limited Warranty iiFCC Part 15 Information iiiInformation for Canadian Users ivThe declarations of CE marking: vContacting ZyXEL vi1

ixControl Card 103 Installation 11Setting up the RS-1612 Rack 11Modem Card 11Phone Lines 12Connecting to Computers 12Hooking Up Power 12NMS Overview 1